in

Tech Forum
Tech Forum » Sensors and Mounting Booms » Third Party Sensors » Any way to measure current in IceFree3 heating coil, like the voltmeter monitors the iPack

Any way to measure current in IceFree3 heating coil, like the voltmeter monitors the iPack

Last post 04-14-2011 6:35 by Matthew. 1 replies.
Page 1 of 1 (2 items)
Sort Posts: Previous Next

  • 07-08-2010 20:01

    Any way to measure current in IceFree3 heating coil, like the voltmeter monitors the iPack

    Reply Contact
    Hello, We will have NRG IceFree3 sensors installed at a remote location where power to the heating coils is sometimes intermittent. Can anyone think of a way to attach some form of sensor to the heating coil that it would interface with the SymphoniePLUS logger so that remote data analysts will know when the power has stopped and thus to throw out any present data from the IceFree3. Thanks for your help.

  • 04-14-2011 6:35 In reply to

    Re: Any way to measure current in IceFree3 heating coil, like the voltmeter monitors the iPack

    Reply Contact
    A bit old for replying, but I would expect that it should work fine to use a voltmeter SCM to monitor the voltage on the heating cable. I haven't implemented this yet, but have considered it for some sites.
Page 1 of 1 (2 items)