Jump to content
Sign in to follow this  
pcorcoran

WindSensor Information: Power Requirements, Wiring & Testing

Recommended Posts

Power Requirements:



When connecting WindSensor anemometers to a SymphoniePLUS3's
preconfigured channels
(1-3, 13-15) an iPack is required
and it should be wired:




  • Brown to Excitation

  • White to Signal




 



This is because these channels use the 12V excitation from
the iPack to create pulses that get fed into the channel as the sensor's Reed
switch turns on and off.



When using the SymphoniePLUS3's flex channels
(4-6) with a Digital Anemometer SCM no iPack is required; in this
configuration it should be wired




  • Brown to Signal

  • White to Ground




 



When using a Symphonie or SymphoniePLUS logger counter
channels
(4-6) with a Digital Anemometer SCM, no iPack is required; in this
configuration it should be wired




  • Brown to (-)

  • White to (+)




 



The Digital Anemometer SCM
routes the logger's 5V through the sensor's Reed switch.



 



WindSensor Test Instructions:



Tools
Required:



  • Digital
    voltmeter (DVM)


 



Instructions
(WindSensor cups NOT spinning):



  • Disconnect
    the WindSensor from the data logger.
  • Set your digital volt meter to
    the 2K ohm scale.
  • Measure the resistance between
    the White wire (+) and Brown Wire (-) -- cups NOT spinning.
  • A reading of either .OL (Open
    Loop) or 0.330 nominally (or 330 ohms). Slowly move the cups and stop once
    you get a reading. Note: the digital volt meter will give a higher reading
    if the cups are spinning, you want to do this extremely slowly and stop
    every time you get a numerical reading. It should settle around 330 ohms when
    the cups not moving.
  • In a single 360 degree rotation of
    the head, you should see the sensor switch from .OL to 330 ohms to .OL to
    330 ohms. Since this is reed switch anemometer, these are the pulses that
    the logger is reading.

Share this post


Link to post
Share on other sites

Join the conversation

You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...