ryanhettenbach Posted March 29, 2017 Report Share Posted March 29, 2017 In the following instructions, using a low pass filter and signal amp are recommended. When wiring a 200P vane to a 5v microcontroller (ie arduino) are there any recommended frequency cutoffs and amp specs that I should be working towards? https://www.renewablenrgsystems.com/assets/resources/anVaneIn.pdf Thanks! Link to comment Share on other sites More sharing options...
pcorcoran Posted March 30, 2017 Report Share Posted March 30, 2017 Hello Ryan, Thank you for your post. My colleague who is highly qualified to answer this question is currently out of the office. I've forwarded your question on to him and hope to have a response for you shortly. If you don't hear from us by the middle of next week shoot an email over to support@nrgsystems.com. Thank you! Pearse Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.